Filename: u159-x7151.up
Content: Firmware for EdgeQAM u159-x
Release Date: 12.Nov.2024
Notes:

7151 (12.Nov.2024)
====

7150 (12.Nov.2024)
====
- Improvement: SD-Card compatibility
- Bugfix: handling of large PAT/PMTs on scrambled services

7130 (03.May.2024)
====
- Bugfix: NIT-TS descriptor order on remote modules
- Improvement: Monitoring page now has a probe-centric structure
- Improvement: measurements of rf channels are updated in tile mode, table mode and the probe info page
- Improvement: visualization of Remap NIT with check against output configuration
- Improvement: tagged VLAN support on DATA interfaces (IGMP / MLD support in VLANs)
- Bugfix: corrupt reception of RTP stream with tagged VLAN
- Improvement: added visualisation of current NIT and current LCN
- Improvement: Reboot device after SI-Processing restart if all IP-RX signal dataloss

6940 (29.Mar.2023)
====
- Improvement: extended LCN range (up to 9999)
- Bugfix: Missing services in LCN-list from remote modules
- Bugfix: NIT-TS deskriptor order on remote modules
- Bugfix: reversed audio and video flags in service analysis
- Bugfix: reactivate decimal point precision for RF channel attenuator
- Improvement: Service analysis can be deactivated with minimum datarate 0
- Improvement: Check common NIT is played out and reset channels in case of failure
- Improvement: Debug-Check EIT is played out 
- Improvement: Component restart option on debug website
- Bugfix: secure NIOS logging to si-processing
- Bugfix: DVBSI-HW Table Filter is reseted on re-trigger failure
- Bugfix: Reception of short SI-tables with adaptation field stuffing
- Bugfix: DVBSI_HW Table Filter reset improved 
- Bugfix: Stuck of DVBSI_HW Table Filter while reception of short SI-tables with AF stuffing
- Improvement: add details to MUX GROUP_STATE_ERROR and SERVICE_STATE_ERROR alarms
- Bugfix: DVBSI-HW Table Filter handle no buffer
- Bugfix: Stuck of display
- Bugfix: clear remaining NIT-Remap alarms 
- Improvement: unified default IP addresses of managment interfaces




